zuggboot

There a few ways on how to apply the lace wigs outlet, and one of the most common is to sew it in. Braiding it in corn rows is the first step you need to follow, so the wig can be placed properly. Rubbing alcohol in your hairline of your forehead will help remove oil and dirt. This is where you will lay the lace once the wig is applied in your head. Applying a scalp protector will keep your skin from direct contact with the glue. It is also used to protect your scalp during hot and humid weather, when you are swimming, and moreover when you have an oily skin. Let it dry after applying the scalp protector to the front hairline. Then apply the adhesive, being careful not to get adhesive to your hairline. Starting at the back slowly put on the wig and stretches it to the front. You can then line up the lace in your desired location and firmly press the lace to the scalp. Using the back of a comb or brush can do the trick. Using a clip, pull up all the hair but leaving an inch down around the back and ears, then start to thread your needle. Sew the lace to the corn rows created earlier. Start at the side of the head moving along the back until you reach the other side. When complete, tie the thread off with a knot. In order to clean the area, rub alcohol with cotton around the hairline twice. Apply the scalp protector before putting a thin layer of adhesive at the back hairline, and press it down firmly to finish the job. You may want to let it dry for about 10 minutes before styling your newly-applied hair wig.